Rfid Access Control User Manual |best| | V2000-c

V2000-C RFID Access Control — User Manual

4. Factory Default Settings

• Master Code: 123456
• Relay Activation Time: 5 seconds
• Door Sensor (Alarm): Disabled

⚠ Change the master code immediately after first installation.

Part 3: First-Time Power-On & Factory Default State

Once wiring is triple-checked, apply power.

• Expected behavior: The device will beep twice. The LED will flash Red/Green once, then settle to Solid Red.
• Default Master Code: 123456 (Six digits).
• Default Lock Release Time: 5 seconds.

Emergency Reset Procedure (Forgot Master Code): V2000-c Rfid Access Control User Manual

1. Power off the V2000-c.
2. Locate the two-pin reset jumper on the PCB.
3. Short the jumper with a shunt or screwdriver.
4. Power on the device while shorted. You will hear a continuous beep.
5. Remove the jumper. The device resets to factory settings (Master code 123456, all users deleted).

4.2 Wiring Diagram (Simplified)

| Controller Terminal | Connects To | | :--- | :--- | | 12V+ / GND | Power adapter (12V DC) | | NO / COM | Electric lock (Normally Open) | | NC / COM | Electric lock (Normally Closed) | | PUSH | Exit button (momentary switch) | | D-IN | Door contact/magnetic sensor |

⚠️ Do not apply AC mains directly to the relay terminals. V2000-C RFID Access Control — User Manual 4

3. Safety & Compliance Warnings

The manual emphasizes the following:

• Low Voltage Precaution: Disconnect power before opening the rear cover to avoid short circuits.
• Environmental: Do not install near strong magnetic fields, RF transmitters (e.g., Wi-Fi routers > 3ft away), or in direct water spray.
• Fire Safety: The access relay must not be used to lock fire exit doors without a mechanical override or break-glass switch.

5.1 Enter Programming Mode

• Action: [Master Code] + #
• Success: 2 beeps + Green LED flashes once.
• Exit: * + # (or wait 15 seconds).

7. Troubleshooting (from manual)

| Problem | Likely cause | Solution | |---------|--------------|----------| | No power | Wrong voltage | Check 12V DC, min 1A | | Card not beeping | Wrong RFID frequency | Use correct card type (125kHz EM) | | Green LED but lock doesn’t open | Relay wiring wrong | Check NO/COM or NC/COM based on lock type | | Buzzer long beep after card | User not enrolled | Add user via programming | | Door open too long alarm | Door contact stuck | Adjust sensor position or disable with 04 0# | Master Code: 123456 Relay Activation Time: 5 seconds

Summary Value

The V2000-C is designed for durability and simplicity. Unlike biometric fingerprint scanners, the RFID + PIN keypad is reliable in dirty, wet, or outdoor environments where fingerprints might fail. It is ideal for construction sites, warehouse gates, and back-entrance doors.

If you need the specific section regarding programming the Master Code or the Wiring Diagram, let me know and I can provide the generic steps for this model.

Note: The exact manual may vary slightly by firmware version. The following is a synthesized, practical guide based on standard features of the V2000-C series.