Epson L3150 Adjustment Program , often called a "resetter," is a utility used to fix the "Service Required"
error. This error typically occurs when the printer's internal Waste Ink Pad counter
reaches its limit, causing the red lights for ink and paper to flash alternately. How to Use the Adjustment Program To reset your Epson L3150, follow these standard steps: Preparation
: Download the resetter tool (often found in technical forums or provided by resellers) and extract the files using a program like : Right-click Adjprog.exe and select Run as administrator Printer Selection as the model, and ensure your printer is connected via USB. Counter Reset Particular Adjustment Mode Waste ink pad counter and click OK. Check the boxes for Main pad counter Platin pad counter (if available). to verify current usage, then click Initialize to reset the counters to zero.
: Turn the printer off and back on when prompted by the software. Important Considerations Ink Pad Hardware resetter adjustment program epson l3150 hot
: Resetting the software does not clean the physical pads. If the pads are saturated, ink may eventually leak. It is recommended to physically clean or replace the waste ink pads. WIC Reset Alternative : If you prefer an official or simplified route, the WIC Reset Utility
can perform this task, though it typically requires purchasing a one-time "Reset Key". Network Reset
: If your issue is purely connectivity-related rather than a "Service Required" error, you can reset the Wi-Fi settings by holding the Network Information buttons simultaneously until the lights flash alternately. Epson L3150 Ink Pad Reset Using Epson Adjustment Program
The Epson Adjustment Program (commonly called a "resetter") is a service utility designed for technicians to reset internal printer counters. For the Epson L3150 (an EcoTank all-in-one inkjet), the main uses are: Epson L3150 Adjustment Program , often called a
AdjProg_xxx.exe and requires a specific "key code" generator (cracked versions bypass this).Short answer: Yes, with precautions.
Long answer: The Epson L3150 has a physical waste ink pad that absorbs excess ink during cleaning cycles. When the counter says 100%, the printer locks down to prevent ink from overflowing and damaging your desk or electronics. However, the pad can often absorb more ink—or you can modify the printer with an external waste ink bottle.
The resetter tool only resets the digital counter. It does not remove the physical ink. If you reset without addressing the waste ink, you risk a real overflow.
Warning: Before running a "hot" reset, ensure you have either: Reset waste ink pad counter – The printer
- Opened the printer and dried/cleaned the waste pads, or
- Installed a waste ink bottle kit (tubing + external container).
If you skip this step and continue printing after the reset, ink will eventually leak out of the printer, potentially damaging its motherboard.
AdjProg.exe, Epson L3150 Resetter.rar, or L3110_L3150_AdjProg.7z).Even with the resetter adjustment program, things can go wrong. Here’s how to fix common issues:
| Problem | Solution | |---------|----------| | Program won't detect printer | Re-enter service mode. Ensure USB cable is directly connected (no hubs). Try a different USB port. | | Error: "Communication error" | Restart both PC and printer. Run the program as admin. | | Counters reset but error returns after 1 print | The waste pads are still physically full. Clean or replace pads, or install external waste tank. | | "Hot" error reappears after 2 days | You may have a short circuit on the logic board (rare). Check for ink spillage inside. | | Program asks for a password | Look for a keygen or default password (e.g., 1234, 0000, or a specific code from the download source). |