Mi A0101 Test Point New «Updated — HACKS»
To locate and use the Mi Pad A0101 (Mi Pad 1) test points for entering EDL mode (9008 port), follow the hardware-level instructions below. This process is typically used to recover bricked devices, bypass accounts, or flash stock firmware when standard methods like Fastboot fail. Mi Pad A0101 Test Point Locations
The test points for the Mi Pad 1 (A0101) are located on the motherboard, requiring you to remove the back cover.
Preparation: Power off the device and carefully pry open the back cover.
Locating the Points: Look near the battery connector or the camera module area.
On the Mi Pad 1, the test points are typically two small golden circular pads located next to each other on the PCB. Note: Ensure you do not confuse them with antenna contacts. Step-by-Step EDL Mode Guide mi a0101 test point new
Disconnect Battery: It is highly recommended to unplug the battery connector from the motherboard to ensure a clean boot into EDL mode.
Short the Points: Use a pair of metal tweezers to bridge (connect) the two identified test points.
Connect to PC: While keeping the points shorted, plug the Mi Pad into your computer using a high-quality USB cable.
Verify Connection: Open Device Manager on your PC. Look under the "Ports (COM & LPT)" section. It should appear as Qualcomm HS-USB QDLoader 9008. To locate and use the Mi Pad A0101
Release Tweezers: Once the PC recognizes the device in 9008 mode, you can stop shorting the points and proceed with tools like the Mi Flash Tool. Troubleshooting
Not Recognized: If it shows as "Unknown Device," ensure you have the Qualcomm QDLoader 9008 Drivers installed.
Mi Account Lock: If you are using this to reset a Mi Account, specialized tools like UnlockTool or Miracle Box are often used after entering EDL mode. BK - Xiaomi Mi A1 EDL Test Point | Facebook Xiaomi Mi Pad 4 Test Point Edl | Tunisia Firmwares Tunisia Firmwares Xiaomi Mi Pad 1 TestPoint | Test Point UnlockTool UnlockTool.Net Xiaomi Mi A1 Test Point - Xiaomi Mi A1 EDL Mode
Xiaomi Mi A1 Test Point | Mi A1 Mi Account Remove File - XDAROM Power off the device
7.1 Preparing the Phone
- Power off the device.
- Remove the SIM, micro‑SD, and battery.
- Connect the test‑point probe (TP‑A ↔ GND).
- Re‑insert the battery while keeping the probe attached.
- Press and hold the Power button for ~3 seconds. The device should now appear as a “Qualcomm HS‑USB Device” (also called “QDL” or “EDL” mode).
Tip: Some users need to press Volume‑Up together with Power to force entry into EDL when the test‑point is active.
Test Report: MI A0101 – Test Point Validation (New Revision)
| Report ID | MI-A0101-TP-001 | | Date | [Insert date] | | Tester | [Name/ID] | | Unit S/N | [Serial number] | | Test Point Label | TP_A0101 |
Risks and Precautions
The new test point method is powerful but not risk-free. Be aware of the following:
- Shorting the wrong pads can send voltage to the wrong IC and permanently fry the motherboard.
- Formatting NVRAM (IMEI, Wi-Fi MAC) can happen if you mistakenly use "Format All + Download" without a backup. You will lose cellular functionality.
- Physical damage – The copper pads can lift off the board if you apply excessive force with tweezers. Use gentle, precise contact.
- Water damage indicators – Opening the phone exposes red LDI stickers; if they change color, service centers may refuse repairs.