Programming Software Verified — Hytera Tc 610
This report outlines the software, hardware, and procedures required for programming the Hytera TC-610 portable analog radio. 1. Software Overview Hytera TC-610
is an analog radio that requires specific Customer Programming Software (CPS) to customize its 16 channels and auxiliary functions. Software Name: Often referred to as PCS610. Version: A common stable version is V6.01.01. hytera tc 610 programming software
Compatibility: Designed for Windows-based operating systems, including Windows 7, 8, and 10. Availability: While the This report outlines the software, hardware, and procedures
is an older model (often listed as EOL - End of Life), software can still be obtained through Hytera authorized dealers or specialized radio software retailers like 49er Communications or Atlantic Radio. 2. Hardware Requirements Install the USB cable driver first (e
To connect the radio to a computer, specific hardware is essential:
USB Programming Cable for HYT TC-610 TC-700 ... - AliExpress
4.1 Driver Installation (Windows 10/11)
- Install the USB cable driver first (e.g., PL2303 driver from Prolific’s official site).
- Plug in the cable – note the COM port number in Device Manager > Ports (COM & LPT).
- Set the COM port to 9600 baud, 8 data bits, no parity, 1 stop bit (software will override, but driver default should match).
2. Required Hardware
- Programming Cable: You need a USB-to-serial or RS-232 programming cable with a Hytera proprietary two-pin connector (similar to Kenwood two-pin but with different pinouts). Many third-party cables are available, but driver stability (Prolific PL2303 or FTDI chipset) is critical.
- PC Compatibility: The software runs on Windows 7, 8, 10, and 11 (32-bit or 64-bit). Older versions may require Windows XP or a virtual machine.
6. Legal & Safety Notice
- License required: Programming frequencies outside amateur or licensed business bands (e.g., marine, public safety) is illegal in most countries. Always operate within your radio license’s terms.
- Backup original data: Always read and save the original configuration before making changes.
Step 1: Connect the Radio
- Turn off your TC-610.
- Plug the programming cable into the side ports (SP for speaker, MIC for microphone).
- Connect the USB or serial end to your PC.
- Turn the radio ON. You should hear a low beep, indicating the radio is in programming standby.
