H-ig41-uatx Rev 1.1 Manual =link=

The H-IG41-uATX (Eton) Rev 1.1 is an Intel G41 Express-based Micro-ATX motherboard designed by Foxconn for HP and Compaq, supporting LGA 775 processors and DDR3 memory. Key documentation covering specifications and jumper settings is available via PartsOkey.ru H-I41-uATX Motherboard Specifications | PDF | Usb - Scribd

The H-IG41-uATX Rev 1.1 (also known as the Foxconn Eton) is a micro-ATX motherboard commonly found in HP and Compaq desktop PCs, such as the HP Compaq 500B. It is built on the Intel G41 Express chipset and supports the LGA 775 socket. Key Technical Specifications Form Factor: Micro-ATX (24.4 cm x 24.4 cm). h-ig41-uatx rev 1.1 manual

Processor Support: Supports Intel Core 2 Quad, Core 2 Duo, Pentium Dual-Core, and Celeron processors with a Front Side Bus (FSB) of up to 1333 MHz. Memory: Two 240-pin DDR3 DIMM slots. The H-IG41-uATX (Eton) Rev 1

Supports up to 4GB of non-ECC, unbuffered DDR3-1333 (PC3-10600) RAM officially. Key settings to check:

Note: Some users report 8GB may work with specific low-spec CPUs. Expansion Slots: 1x PCI Express x16. 2x PCI Express x1. 1x Mini PCI slot (often for wireless cards). Storage: 4x SATA II (3.0 Gb/s) ports.

Rear I/O Ports: 1x VGA, 4x USB 2.0, 1x RJ-45 LAN (Realtek RTL8103E), and 3x Audio jacks (Realtek ALC662). Critical User Manual Information Foxconn H-IG41-uATX (REV:1.0) - The Retro Web

---

Key settings to check:

• SATA Mode: Only IDE or Native IDE (no AHCI – ICH7 in G41 typically lacks AHCI without mod).
• Onboard VGA: Set DVMT memory size (128MB recommended for Windows 7/XP).
• CPU Features: Enable/disable C-states, Virtualization (VT-x) if CPU supports it.
• Wake-on-LAN: Found under Power Management → Wake on PCI/PME.

---

Expansion Cards

• PCIe x16 – For a graphics card (low-power models only – e.g., GT 710, GT 1030, Radeon R5 240). Power draw must be ≤ 75W (no external power needed unless card requires it).
• PCI – For sound cards, older network cards, etc.

---

Chipset Tab

• North Bridge: Configure integrated graphics memory (DVMT). Default is 64MB. Increase to 256MB for Windows 7 Aero.
• South Bridge: SATA mode – choose IDE (for XP), AHCI (for Windows 7+, requires driver on floppy/USB).

Executive summary

This report summarizes the H-IG41-UATX Rev 1.1 manual, highlighting scope, key features, installation and setup steps, configuration and usage guidance, maintenance and troubleshooting, safety and compliance, and recommended improvements.

1. Scope and purpose

• Device: H-IG41-UATX (hardware product; Rev 1.1).
• Manual purpose: provide installation, configuration, operation, maintenance, and safety instructions for end users and technicians.
• Intended audience: system integrators, IT administrators, field technicians.