Amada Pega 357 User Manual Link -

The Complete Guide to the Amada PEGA 357 User Manual: Operation, Maintenance, and Troubleshooting

2.4 Tooling Setup Guide

This is the most referenced part of the manual. It details:

  • Station identification (A, B, C, D, E stations and their tonnage limits).
  • Stripper plate adjustment for thick vs. thin material.
  • Punch and die concentricity checks.
  • Tool length specifications (Amada’s "Thick Turret" tooling standard).

3.3 Turret Station Layout and Tool Setup

A full diagram shows stations 1 through 58. The manual explains: amada pega 357 user manual

  • Station types (A, B, C, D, E stations for different punch sizes).
  • How to orient punch and die alignment using the turret’s index marks.
  • Stripper adjustment – too little stripping pressure can lift the sheet; too much can mark the material.

Problem #1: Turret indexing stalls with “Turret Clamp” alarm

Manual solution (Section 5.4):

  • Cause: Chip buildup under turret coupling.
  • Fix: Jog turret manually (using the manual index button), then blow compressed air into the coupling gap. If persists, adjust proximity switch PRX-12 to 1.5mm gap.

Problem #3: CNC display shows “OT” (over-travel) on Y-axis

Manual solution (Section 7.3 – Limit Switch Adjustment): The Complete Guide to the Amada PEGA 357

  • Cause: Sheet edge hit the Y-axis limit.
  • Fix: Press “Limit Override” button (location shown in Figure 7-5) and jog back. Then check your program’s sheet clamp positions against the manual’s travel diagram (Table 7-2: Y max = 40” for standard clamps).

1. Amada America’s Official Portal

Amada maintains a technical documents service for registered owners. Contact Amada’s parts and service department with your machine’s serial number. They can supply a PDF of the original amada pega 357 user manual for a fee. Station identification (A, B, C, D, E stations

Share This