Adaptar Fuente De Pc A Ps4 Fat ^new^ -

Informative Report: Adapting a Standard ATX PC Power Supply for Use with a PlayStation 4 (Fat Model)

Step 1: Opening the PS4 Fat and Removing the Original PSU

Disconnect the PS4 from AC power and remove the HDD cover.
Remove the 7 Torx security screws (T8) on the back and side.
Slide off the top cover, then the power supply shielding.
Unplug the PSU’s internal cable from the motherboard. Take a photo of the connector pinout. Use your multimeter to verify voltages when the console is plugged in (standby mode). Write down which pin is 3.3V SB, 5V SB (if any), and the PS_ON signal location.

On most PS4 Fat (CUH-11xx), the motherboard header is a 6-pin (2x3). Pinout often is:

Top row: 12V, 12V, GND
Bottom row: GND, 5V, 3.3VSB

But confirm with a multimeter.

5. Procedure Outline

Disassemble PS4 Fat – remove top cover, shielding, and original PSU.
Extract original PSU connector – cut it from the dead PSU board (if available) or use a generic 2.5mm pitch 6-pin connector.
Prepare ATX PSU – open the case (⚠️ safety risk – capacitors hold charge) or work externally.
Solder connections as per the table above. Use heat shrink tubing.
Test before full assembly – connect PSU to mains, PS4 motherboard only (no disc drive initially). The console should enter standby (orange light).
Press power button – green light, fan spin, video output.
Secure the ATX PSU externally – it will not fit inside the PS4 case. Typical placement: next to console, inside a custom enclosure, or cut into the top cover.

Why Do This? The Pros and Cons

4. Connect wires

Solder / crimp to female connector:

| PS4 pin | Connect to | |---------|-------------| | +12V (3 wires) | ATX yellow | | GND (3 wires) | ATX black | | 5VSB | ATX purple | | PS_ON | ATX green | adaptar fuente de pc a ps4 fat

Do not connect +5V red wires from ATX anywhere. Informative Report: Adapting a Standard ATX PC Power

Adaptar fuente de PC a PS4 Fat

Advertencia breve: hacerlo implica riesgos (daño a la consola, incendio, anulación de garantía). Procede solo si entiendes electrónica y tomas medidas de seguridad. Disconnect the PS4 from AC power and remove the HDD cover